Are you not able to connect Netgear Nighthawk WiFi extender to iPad? You might be following the incorrect setup steps then. Walk through the below mentioned points and learn how to connect an iPad to the WiFi extender’s network. However, you can read further to know the troubleshooting hacks to be followed in case the connection fails.
In case you have disabled the SSID broadcast of your Netgear Nighthawk extender, you need to select Other and enter the SSID and WiFi password of the extender. You might also be asked to enter the security type of the extender’s network.
This is how to connect Netgear Nighthawk WiFi extender to iPad. Confirm the connection by launching Safari on iPad and visiting mywifiext page. On the off-chance, the given steps fail to help you out, you can use the following section to fix the problem.
Before you jump ahead to any troubleshooting tip, ensure that you have used the correct WiFi password of the Netgear Nighthawk extender. It must have been entered without any typing errors. In case, you are still unable to establish a connection.
There are chances that you are attempting to connect to the Netgear Nighthawk WiFi extender network outside its WiFi signal range. So, come a little closer to the WiFi extender and see if you are able to connect your iPad now.
Some Netgear extenders are dual-band. May be you are trying to connect to the 2.4GHz network and entering the WiFi password of 5GHz network. Rectify your mistake right away by using the correct details.
There can be technical glitches that are not allowing your iPad to get connected to the Nighthawk extender WiFi. To dispose them, simply reboot your iPad. For that, press and hold the device’s Volume button and the top button until you see the Power Off slider. Drag the slider and wait for 30 seconds. Your iPad will turn off. To turn it back on, simply press and hold the Volume and the top button and wait for the Apple logo to appear.
Probably, you have blocked internet access to iPad either from the extender’s menu or from the main router’s menu. To make sure that, you are recommended to perform Netgear Nighthawk login using another device and check the Access Control list. If your iPad has been denied the internet access, you are suggested to remove it from that list. On the off-chance, you’ve blocked it from the router, access the router’s web GUI from a device connected to its network.
It is not very difficult to connect Netgear Nighthawk WiFi extender to iPad. But, problems can arise at any time. With the hacks given in this post, you will be able to fix the problem and connect your devices successfully.
Tags: Connect Nighthawk WiFi Extender to iPad, Nighthawk Extender Setup