Netgear router users consider performing Netgear firmware update in order to enhance the performance of their routers. However, what good is the Netgear router firmware update process when instead of fixing them; it has to cause more issues? What we mean to say is that recently, users have been facing the Netgear remote management option not visible issue right after performing firmware update.
If you are also in the same boat, then take a chill pill. In this post, we have covered some troubleshooting tips that will assist you to rectify the issue at hand in the blink of an eye. Thus, quit waiting and get down to reading.
Technical glitches hold enough power to ruin the performance of a Netgear router. Taking this into consideration, we have brought forward the very reason behind the Netgear remote management option not visible issue.
But, the good news here is that you can eliminate these glitches by giving your wireless device a restart. In order to do so, power off your router, wait for a couple of seconds, and then, turn back your router on.
Although restarting your device would’ve put an end to the Netgear remote management option not visible issue, in case, it did not; it is probably because of a weak internet connection. The first reason behind a weak internet is a fault from your ISP’s end.
Therefore, ping your Internet Service Provider and ask him to fix the issue. If his efforts don’t help you out either, then you should consider contacting our technical experts.
Another reason behind a weak internet is an unstable Ethernet connection between your Netgear wireless router and the existing modem.
Have a look at the Ethernet cable connecting your devices. By any chance, if you find cuts on or in it, bring a new cable home. Also, ensure that the connection between your router and modem is not loose.
Another thing that can be done by you to rectify the Netgear remote management option not visible issue is to reduce the distance between your router and the modem.
The reason being, too much distance between your devices can make it next to impossible for them to transmit signals properly. Therefore, do the necessary before it gets too late.
In order to successfully enable the Netgear remote management option on your wireless router, you need to access the BASIC Home screen. And that is only possible if you use the correct username and password.
Therefore, make sure that you are entering the correct login credentials on the Netgear router login page in order to log in to your device with ease.
Once you are done taking the help of these troubleshooting hacks, try to enable the Netgear remote management option via routerlogin.net by following the instructions given below.
Although these steps will surely help you to enable Netgear remote management on your router, in case, it does not, repeat the same process using the IP address, i.e. 10.0.0.1.
Performing Netgear firmware update improves the functionality of a router, but sometimes, it can also cause issues. We hope that after taking the help of the aforementioned steps, you were able to troubleshoot the Netgear remote management option not visible issue.
On the off chance, you are still going nuts because of the same; waste no more time reaching out to our technicians. Whether you ping them in the day or at night, they are always available to help out users struggling with Netgear router-related issues.
